Fujitsu 200 Kullanıcı Talimatları - Sayfa 2

Depolama Fujitsu 200 için çevrimiçi göz atın veya pdf Kullanıcı Talimatları indirin. Fujitsu 200 2 sayfaları. Harsh environment case for pencentra 130
Ayrıca Fujitsu 200 için: Kullanıcı Kılavuzu (2 sayfalar), Şartname Sayfası (2 sayfalar), Kullanıcı Kılavuzu (8 sayfalar), Kullanıcı Kılavuzu (2 sayfalar), Kullanıcı Talimatları (1 sayfalar), Kullanıcı Talimatları (1 sayfalar)

2. For installation on the harsh environment case

(HEC), remove the edge from the screen protector,

as shown in Figure 4.

Figure 4. Removing Screen Protector Edge Strip

3. Peel the protective film from the adhesive side of

screen protector as shown in Figure 5.

Figure 5. Removing Adhesive Backing

4. Apply the screen protector with the adhesive side

down and the notch in the lower left corner as

shown in Figure 6. Apply pressure along the edges

of the screen protector with your finger. (Avoid

lifting the screen protector from the display

window after it is installed. The adhesive requires

48 hours to cure completely.

Figure 6. Applying the Screen Protector

2 of 2

5. Remove the protective film from the top surface of

the screen protector as shown in Figure 7.

Figure 7. Peeling the Protective Film

6. Wipe the exposed surface of the screen protector

with a clean dry cloth to remove any tacky residue

left behind by the protective film. If necessary, clean

the surface of the HEC window with a soft cotton

cloth dampened with denatured alcohol to remove

the residue.

Using the carrying strap and hand straps

The carrying strap assembly can be attached to either

end of the HEC, depending upon your preference.

Attach the clips to either the left or right set of

d-rings.

One or both of the two elasticized handstraps can be

used. Slide your hand between one or both straps

(whichever is most comfortable) and the HEC.

D-rings (one of four)

Figure 8. HEC Handstrap Assembly

Handstraps

58-0671-00B