AEG ProSense LF694ABC Kullanıcı Kılavuzu - Sayfa 23
Yıkayıcı AEG ProSense LF694ABC için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. AEG ProSense LF694ABC 40 sayfaları.
Sayfayı YazdırThe programme or the delay start continues.
4. The door can be opened when the
programme is complete, or set spinning
or draining programme/option and than
press Start/Pauze button.
12.12 End of the programme
When the programme has finished, the
appliance stops automatically. The acoustic
signals operate (if they are active).
In the display all washing phase indicators
become steady and the time area shows .
The indicator of the Start/Pauze button goes
off.
The door unlocks and the indicator
off.
1. Press the Aan/Uit button to deactivate the
appliance.
After five minutes from the end of the
programme, the energy saving function
automatically deactivates the appliance.
When you activate the appliance again,
the display show the end of the last
selected programme. Turn the
programme dial to set a new cycle.
2. Remove the laundry from the appliance.
3. Make sure that the drum is empty.
4. Keep the door and the detergent
dispenser slightly ajar to prevent mildew
and odours.
5. Close the water tap.
12.13 Draining water out after end
of cycle
If you have chosen a programme or an option
that does not empty out the water of the last
rinse, the programme is completed, but:
• The display shows the door locked
indicator
13. HINTS AND TIPS
WARNING!
Refer to Safety chapters.
• The drum still turns at regular intervals to
prevent the creases in the laundry.
• The door stays locked.
• You must drain the water to open the
door:
1. If necessary, touch the Centrifugeren
button to decrease the spin speed
proposed by the appliance.
2. Press Start/Pauze to continue the cycle
3. When the programme is completed and
the door locked indicator
you can open the door.
4. Press the Aan/Uit button a few seconds
to deactivate the appliance.
goes
In any case, the appliance empties the
water out automatically after
approximately 18 hours.
12.14 Stand-by option
The Stand-by function automatically
deactivates the appliance to decrease the
energy consumption when:
• You do not use the appliance for 5
minutes before you touch the Start/Pauze
button.
Press the button Aan/Uit to activate the
appliance again.
• After 5 minutes from the end of the
washing programme
Press the Aan/Uit button to activate the
appliance again.
The display shows the end of the last set
programme.
Turn the programme dial to set a new
cycle.
If you set a programme or an option that
ends with water in the drum, the Stand-
by function doesn't deactivate the
appliance to remind you to drain the
water.
13.1 The laundry load
• Divide the laundry into: white, coloured,
synthetics, delicates and wool.
goes off,
ENGLISH
23