AEG ProSense LF694ABC Kullanıcı Kılavuzu - Sayfa 25

Yıkayıcı AEG ProSense LF694ABC için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. AEG ProSense LF694ABC 40 sayfaları.

Sayfayı Yazdır

– there is large amounts of foam during

washing.

• When using detergent tabs or pods,

always put them inside the drum, not in

the detergent dispenser.

Insufficient detergent may cause:

• unsatisfactory washing results,

• the wash load to turn grey,

• greasy clothes,

• mould in the appliance.

Excessive detergent may cause:

• sudsing,

• reduced washing effect,

• inadequate rinsing,

• a greater impact for the environment.

13.4 Ecological hints

To save water, energy and to help protect the

environment, we recommend that you follow

these tips:

• Normally soiled laundry may be washed

without prewash in order to save

detergent, water and time (the

environment is protected too!).

• Loading the appliance to the maximum

capacity indicated for each

programmes helps to reduce energy

and water consumption.

14. CARE AND CLEANING

WARNING!

Refer to Safety chapters.

14.1 Periodic cleaning schedule

Periodic cleaning helps to extend the life

of your appliance.

After each cycle, keep the door and the

detergent dispenser slightly ajar to get air

circulation and dry the humidity inside the

appliance: this will prevent mildew and

odours.

If the appliance is not used for a long time:

close the water tap and unplug the appliance.

Indicative periodic cleaning schedule:

Descaling

Twice a year

• With adequate pre-treatment, stains and

limited soiling can be removed; the

laundry can then be washed at a lower

temperature.

• To use the correct quantity of detergent,

refer to the quantity suggested by the

detergent producer and check the water

hardness of you domestic system. Refer

to 'Water hardness'.

• Set the maximum possible spin speed

for the selected washing programme

before drying your laundry in a tumble

dryer. This will save energy during drying!

13.5 Water hardness

If the water hardness in your area is high or

moderate, we recommend that you additive

for water softening. In areas where the water

hardness is soft it is not necessary to use

him.

To find out the water hardness in your area,

contact your local water authority.

Use the correct quantity of additive for water

softening. Follow the instructions that you find

on the packaging of the product.

Maintenance wash

Clean door seal

Clean drum

Clean detergent dispens‐

Clean drain pump filter

Clean the inlet hose and

the valve filter

The following paragraphs explain how you

should clean each part.

Once a month

Every two months

Twice a year

ENGLISH