AC Schnitzer 5112 210 110 Montaj Talimatları Kılavuzu - Sayfa 16

Otomobil Aksesuarları AC Schnitzer 5112 210 110 için çevrimiçi göz atın veya pdf Montaj Talimatları Kılavuzu indirin. AC Schnitzer 5112 210 110 16 sayfaları. Rear skirt extension f10 / f11

Sayfayı Yazdır

Pa in t in g In s t r u c t io n s

Notes on Painting AC Schnitzer Components

Before painting, check the fit of all AC Schnitzer bodystyling components on the vehicle (e.g. support surfaces/contours).

Any retouching work (e.g. sanding of support surfaces/contours) should be carried out before painting!

The quality and durability of the paint on a component depend on the preparation and are affected by external influences,

and cannot therefore be compared with other body parts.

To prevent distortion/deformation during processing and drying, AC Schnitzer components must be placed on a

corresponding jig.

Note!

The manufacturer's painting instructions must be followed!!

Painting Steps:

1. Clean:

2. Temper:

3. Inspect:

4. Sand:

5. Mask off:

6. Clean:

7. Fill:

8. Dry:

9. Remove:

10. Sand:

11. Clean:

12. Mask off:

13. Paint:

14. Dry:

AC Schnitzer - automobile Technik - Neuenhofstraße 160 - 52078 Aachen - Tel. 0241/5688 -130

Plastic cleaner / Silicone remover

30 min. at max. 40° Celsius object temperature

Sand down surfaces edges and seams (any pores) if required

2K stopper P220 – P280 (dry), complete component P400 – P600 (dry)

Contact surfaces, TÜV plate, rating plates

Silicone remover

2K HS-filler

1 hour at max. 40° Celsius object temperature, leave component in drying

cabinet overnight

Masking on rating plates, contact surfaces and TÜV plate

P800 (dry)

Silicone remover

Contact surfaces

Note manufacturer's technical data and painting instructions

1 hour at max. 40° Celsius object temperature, leave component in drying

cabinet overnight

Painting Instructions Issue: 10/2010

Fax -135