Indesit BTW A51052 Kullanıcı Kılavuzu - Sayfa 20

Yıkayıcı Indesit BTW A51052 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Indesit BTW A51052 26 sayfaları.

Sayfayı Yazdır

TROUBLESHOOTING

Your washing machine is equipped with various automatic safety and feedback functions . They enable failures and needed
maintenance to be detected and indicated accordingly . These failures are frequently so minor that they can be removed within
a few minutes .
Anomalies:
The washing machine does not
turn on and/ or programme does
not start
The wash cycle does not start
Appliance stops during the
programme, and the
"Start/Pause" light blinks
Detergent dispenser contains
residues from detergent/
additives at end of wash
Appliance vibrates
Final spin results are poor . The
laundry is still very wet . "Spin/
Drain" indicator blinks, or the
spin speed indicator blinks after
the end of the programme -
depending on the model
Programme duration is
considerably longer or shorter as
indicated in the "PROGRAMME
CHART"
16
Possible causes / Solution:
•
The plug is not inserted into the electrical outlet, or not enough to make contact .
•
There has been a power failure .
•
Socket or fuse does not function correctly (use a table lamp or similar appliance to
test it) .
•
Lid is not properly closed .
•
The "Start/Pause"
button has not been pressed .
•
The water tap is not open .
•
A "Start delay" has been set .
•
"Rinse hold" option is activated (if available) . Terminate "Rinse hold" by pressing
"Start/Pause"
or by pressing the "Reset/Drain" button for at least 3 seconds starting
"Drain" cycle .
•
Programme has been changed - re-select desired programme and press "Start/Pause"
•
The appliance's safety system has been activated (see USER MANUAL/ Description of failure
indicators) .
•
Water tap is not opened or water inlet hose is kinked .
•
Detergent dispenser is not properly installed, or detergent dispenser is blocked
(see "CLEANING & MAINTENANCE") .
•
Filter in the water inlet hose is blocked (see "CLEANING & MAINTENANCE") .
•
The washing machine is not level .
•
The transport bracket has not been removed; before using the washing machine,
the transport bracket must be removed .
•
Unbalance of the laundry load during spinning prevented the spin phase to avoid
damages on the washing machine . This is why the laundry is still very wet . Reason
for unbalance can be: small laundry loads (consisting of only few quite big or
absorbent items, e . g . towels), or big/heavy laundry items .
•
If possible avoid small laundry loads .
•
Excessive foam formation prevented spinning; select and start "Rinse + Spin"
programme . Avoid excessive detergent dosing .
•
"Spin speed" button has been set to a low spin speed .
•
It is highly recommended that you add other laundry items of different sizes when
washing a big or heavy piece of laundry .
•
Normal function of the washing machine to adapt to factors that can have an
effect on the programme duration, like excessive foam formation, load unbalance
due to heavy laundry items, prolonged heating time resulting from low inlet water
temperature etc . Moreover, the sensing system of the washing machine adapts the
programme duration to the size of the wash load .
•
Depending on these factors, the duration is recalculated during the programme
and updated if necessary .
•
For small loads, the programme time indicated in the "PROGRAMME CHART" may
be reduced by up to 50% .
User manual
.