Indesit BTW A51052 Kullanıcı Kılavuzu - Sayfa 21

Yıkayıcı Indesit BTW A51052 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Indesit BTW A51052 26 sayfaları.

User manual

DESCRIPTION OF FAILURE INDICATORS

Failure indicator

Possible causes / Solution

lights up:

Failure: Call After-sales service

Service

• Refer to Troubleshooting section

• If faults persist, unplug the appliance, turn off the water tap and contact our After-sales service .

Appliance has no or insufficient water supply . The "Start/Pause"

• Water tap is fully open and water supply pressure is sufficient .

• Kinks are present in water inlet hose .

• Mesh filter of water supply hose is blocked (see "CLEANING & MAINTENANCE") .

• Water hose is frozen up .

Water tap closed

• Safety valve inspection window of your water supply hose is red (provided your appliance has a water

supply hose, (see previous chapter "CLEANING & MAINTENANCE/ CHECKING THE WATER SUPPLY

HOSE"); replace the hose by a new one available through our After-sales service or your specialist

dealer .

After problem has been removed, restart programme by pressing "Start/Pause" . If the fault occurs

again, contact our After-sales service .

Waste water is not pumped out . The appliance stops in the corresponding programme step; unplug it

and check whether:

• Kinks are present in the drain hose .

• Filter or pump is blocked (see chapter "CLEANING & MAINTENANCE/ CLEANING THE WATER FILTER /

Clean filter

DRAINING RESIDUAL WATER"); make sure the water has cooled before draining the appliance .

• The drain hose is frozen up .

After problem has been removed, push "Reset/Drain" button for at least 3 seconds to drain the water .

If the fault occurs again, contact our After-sales service .

All lamps of the

•

Drum flaps open

Washing phase

•

Appliance stops during the programme . The drum flaps have not been closed properly . Push the

indicator light

"Reset/Drain" button for at least 3 seconds and wait until the "Door closed" light turns off . Open lid

and close drum flaps, then select and start desired programme again . If fault persists, contact our

After-sales service .

light blinks . Check whether: