Indesit BTW A51052 User Manual - Page 21

Browse online or download pdf User Manual for Washer Indesit BTW A51052. Indesit BTW A51052 26 pages.

Print Page

User manual

DESCRIPTION OF FAILURE INDICATORS

Failure indicator

Possible causes / Solution

lights up:

Failure: Call After-sales service

Service

• Refer to Troubleshooting section

• If faults persist, unplug the appliance, turn off the water tap and contact our After-sales service .

Appliance has no or insufficient water supply . The "Start/Pause"

• Water tap is fully open and water supply pressure is sufficient .

• Kinks are present in water inlet hose .

• Mesh filter of water supply hose is blocked (see "CLEANING & MAINTENANCE") .

• Water hose is frozen up .

Water tap closed

• Safety valve inspection window of your water supply hose is red (provided your appliance has a water

supply hose, (see previous chapter "CLEANING & MAINTENANCE/ CHECKING THE WATER SUPPLY

HOSE"); replace the hose by a new one available through our After-sales service or your specialist

dealer .

After problem has been removed, restart programme by pressing "Start/Pause" . If the fault occurs

again, contact our After-sales service .

Waste water is not pumped out . The appliance stops in the corresponding programme step; unplug it

and check whether:

• Kinks are present in the drain hose .

• Filter or pump is blocked (see chapter "CLEANING & MAINTENANCE/ CLEANING THE WATER FILTER /

Clean filter

DRAINING RESIDUAL WATER"); make sure the water has cooled before draining the appliance .

• The drain hose is frozen up .

After problem has been removed, push "Reset/Drain" button for at least 3 seconds to drain the water .

If the fault occurs again, contact our After-sales service .

All lamps of the

•

Drum flaps open

Washing phase

•

Appliance stops during the programme . The drum flaps have not been closed properly . Push the

indicator light

"Reset/Drain" button for at least 3 seconds and wait until the "Door closed" light turns off . Open lid

and close drum flaps, then select and start desired programme again . If fault persists, contact our

After-sales service .

light blinks . Check whether: