Indesit BTW A51052 Manual do utilizador - Página 21

Procurar online ou descarregar pdf Manual do utilizador para Máquina de lavar roupa Indesit BTW A51052. Indesit BTW A51052 26 páginas.

User manual

DESCRIPTION OF FAILURE INDICATORS

Failure indicator
Possible causes / Solution
lights up:
Failure: Call After-sales service
Service
• Refer to Troubleshooting section
• If faults persist, unplug the appliance, turn off the water tap and contact our After-sales service .
Appliance has no or insufficient water supply . The "Start/Pause"
• Water tap is fully open and water supply pressure is sufficient .
• Kinks are present in water inlet hose .
• Mesh filter of water supply hose is blocked (see "CLEANING & MAINTENANCE") .
• Water hose is frozen up .
Water tap closed
• Safety valve inspection window of your water supply hose is red (provided your appliance has a water
supply hose, (see previous chapter "CLEANING & MAINTENANCE/ CHECKING THE WATER SUPPLY
HOSE"); replace the hose by a new one available through our After-sales service or your specialist
dealer .
After problem has been removed, restart programme by pressing "Start/Pause" . If the fault occurs
again, contact our After-sales service .
Waste water is not pumped out . The appliance stops in the corresponding programme step; unplug it
and check whether:
• Kinks are present in the drain hose .
• Filter or pump is blocked (see chapter "CLEANING & MAINTENANCE/ CLEANING THE WATER FILTER /
Clean filter
DRAINING RESIDUAL WATER"); make sure the water has cooled before draining the appliance .
• The drain hose is frozen up .
After problem has been removed, push "Reset/Drain" button for at least 3 seconds to drain the water .
If the fault occurs again, contact our After-sales service .
All lamps of the
Drum flaps open
Washing phase
Appliance stops during the programme . The drum flaps have not been closed properly . Push the
indicator light
"Reset/Drain" button for at least 3 seconds and wait until the "Door closed" light turns off . Open lid
up
and close drum flaps, then select and start desired programme again . If fault persists, contact our
After-sales service .
light blinks . Check whether:
EN
17