AEG SANTO 75428 DT Kullanıcı Kılavuzu - Sayfa 22

Dondurucu AEG SANTO 75428 DT için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. AEG SANTO 75428 DT 46 sayfaları.

Malfunction

Unusual noises.

The compressor does not start

immediately after changing

the temperature setting.

Water on the floor or on

storage shelves.

Changing the light bulb

Warning! There is a risk of electric shocks! Before changing the light bulb,

switch off the appliance and unplug it, or pull the fuse or the circuit breaker.

Light bulb data: 220-240 V

To switch off the appliance, Unplug

the mains plug.

If it becomes necessary to replace the

lamp, prize out the lamp cover as

shown in the figure.

Change the defective light bulb with

one of the some power (the

maximum power is shown on the

light diffuser).

Refit the light bulb cover.

Put the appliance back into

operation.

Possible Cause

Appliance is not level.

The appliance is touching the

wall or other objects.

A component, e.g. a pipe, on

the rear of the appliance is

touching another part of the

appliance or the wall.

This is normal, no error has

occurred.

Water drain hole is blocked.

Remedy

Readjust the feet.

Move the appliance slightly.

If necessary, carefully bend

the component out of the

way.

The compressor starts after a

period of time.

See the "Cleaning and Care"

section.