Kohler BELAY K-156T-LCP Kurulum Talimatları Kılavuzu - Sayfa 17
Banyo Armatürleri Kohler BELAY K-156T-LCP için çevrimiçi göz atın veya pdf Kurulum Talimatları Kılavuzu indirin. Kohler BELAY K-156T-LCP 23 sayfaları.
Sayfayı Yazdır
·
Fill the bath at least 2" (51 mm) above the highest
whirlpool jets.
·
Press the air switch actuator to turn the whirlpool on.
The in-line heater will turn on automatically.
·
Press the air switch actuator a second time to turn
the whirlpool and in-line heater off.
·
When you are done bathing, open the drain and
remain seated while the water drains from the bath.
·
When the water has drained from the bath, unlatch
and open the door.
·
Carefully exit the bath.
Adjust Air/Water Mix
·
Adjust each jet for optimum air/water mixture. Turn
the jet trim clockwise to reduce air flow, or
counterclockwise to increase air flow.
Flush the Whirlpool System
NOTE: Flush the whirlpool system twice a month or
more, depending on usage.
·
Turn the jet trim rings fully clockwise to block air
induction.
·
Fill the bath with warm water at least 2" (51 mm)
above the highest jets, or leave water in the bath
after use.
·
Add 2 teaspoons (10 ml) of a low-foaming, powder
automatic dishwasher detergent and 20 ounces
(590 ml) of household bleach (5% - 6% sodium
hypochlorite) to the water.
·
Run the whirlpool for 5 to 10 minutes. Turn off the
whirlpool and drain.
·
Rinse the surfaces of the bath, jets, faucet,
handrails, and drain. Wipe dry with a soft cloth.
1397340-T01-A
Fill with water at least 2" (51 mm) above the highest jet.
Turn the jet trim ring clockwise
to decrease the flow.
Turn the jet trim ring counterclockwise to increase the flow.
-17-
·
·
·
·
·
·
/
·
·
·
·
2
10 ml
20
590 ml
·
5-10
·
2"
51 mm
Position the jet nozzles to
direct the water flow as desired.
2" 51 mm
/
2" 51 mm
5% - 6%