Kohler BodySpa K-1000 Kurulum Talimatları Kılavuzu - Sayfa 5
Banyo Armatürleri Kohler BodySpa K-1000 için çevrimiçi göz atın veya pdf Kurulum Talimatları Kılavuzu indirin. Kohler BodySpa K-1000 28 sayfaları. Tower custom hydro-massage system
Ayrıca Kohler BodySpa K-1000 için: Ev Sahibi El Kitabı (48 sayfalar)
Sayfayı Yazdır
C. CONSTRUCT THE APRON
TE:
NO
Kohler Co. recommends this procedure for
constructing a BodySpa apron. Other methods can be
used to obtain an acceptable result.
1.
Cut four 3/4" plywood boards to 6" x 34-1/4".
Measure and cut a 55_ taper at one end of each
board, and a 75_ taper at the other end. Both ends
must taper to the same side.
2.
Draw a pencil mark 3" from the long side of one of the
boards at the 75_ taper end. Draw a second mark 5"
from the long side, as shown.
3.
Use a pencil, string, and nail to carefully draw a
51-1/4" radius (for 1/2" thick finished wall) across the
full length of the board at the 3" pencil mark. For
different finished wall thickness, adjust this radius
accordingly. Draw a 49-1/4" radius across the 5"
pencil mark.
4.
Use a saber saw to cut the plywood along the radius
lines.
5.
Use this board as a template to mark and cut the
other three plywood boards.
6.
Cut four 3/4" plywood boards to 2" x 6", with a 50_
taper on one end.
7.
Cut twelve 2x2 studs 9" long.
8.
Assemble the apron frame sections as shown.
9.
Position the apron frame sections under the footbath
rim so the 75_ tapered ends of the curved sections
touch. Align the apron frame sections so they are
recessed correctly for the finished apron wall
thickness. Make sure the sections are plumb.
10. Secure the apron frame sections to the floor.
Kohler Co., Kohler WI U.S.A.
5"
75_
3"
51-1/4" R.
49-1/4" R.
2"
3/4" Plywood
2x2 Studs
9"
3/4" Plywood
5
34-1/4"
55_
Measure 3" and 5"
Down From This
Edge
6"
50_
10-1/2"
116290-2-
6"
AB