AEG TR8TRIER Kullanıcı Kılavuzu - Sayfa 18
Kurutucu AEG TR8TRIER için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. AEG TR8TRIER 32 sayfaları.
Sayfayı Yazdır3. Touch and hold down + Antikreuk button
by around 3 seconds.
The symbol
appears on the display.
4. To deactivate the child lock, touch the
above button again until the symbol
disappears.
8.8 Starting a program
To start the program:
Touch the Start/Pauze button.
The appliance starts and the LED above the
button stops flashing and stays on.
8.9 The ProSense load detection
The ProSense The ProSense technology
detects the laundry load size defining the
programme duration.
After setting a drying programme, the
icon lights up on the display if
the programme supports it.
Touching the Start/Pauze button, the
ProSense starts the laundry load detection:
1. The appliance detects the load in the first
minute: the indicator flashes, the bars
under the icon move back and forth
and the drum rotates shortly.
2. When the drum stops rotating, the display
shows the new programme duration
adjusted according to the detected load.
The number of bars, from 1 to 4,
represents the estimated load amount. 4
bars represent the maximum load amount
for the selected programme.
18
ENGLISH
In case of drum overload, the maximum
declared load indicator comes on again
with the
indicator blinking. In
this case, during these 30 seconds, it is
possible to open the door and remove
the exceeding garments. Once removed,
touch the Start/Pauze button to start the
programme again. If the laundry amount
will not be reduced, the programme starts
anyway. In this case, it will be not
possible to guarantee the best results.
8.10 Program change
To change a program:
1. Push the Aan/Uit button to turn the
appliance off.
2. Push the Aan/Uit button again to turn on
the appliance.
3. Set a new program.
8.11 Programme end
Clean the filter and drain the water
container after each drying cycle. (See
chapter CARE AND CLEANING.)
If the drying cycle is finished, the symbol
appears on the display. If the Zoemer option
is activated, the acoustic signal sounds
intermittently for 1 minute.
If you do not turn off the appliance, the
anti-crease phase starts (not active with
all programmes). Flashing
signals the execution of the anti-crease
phase. Laundry can be removed during
this phase.
To remove the laundry:
1. Push the Aan/Uit button for 2 seconds to
turn the appliance off.
2. Open the appliance door.
3. Remove the laundry.
4. Close the appliance door.
symbol