ACADEMY Summit Classic Deluxe Tripod 12 Leg Kit Manuel - Sayfa 3
Aksesuarlar ACADEMY Summit Classic Deluxe Tripod 12 Leg Kit için çevrimiçi göz atın veya pdf Manuel indirin. ACADEMY Summit Classic Deluxe Tripod 12 Leg Kit 8 sayfaları.
LEG ASSEMBLY
1. Carefully lay the completed 81518 top section on its side
- ladder rungs up as shown in figure 1.
2. Position one of the Couple Plates as shown in figure 2.
Slide the plate over the leg and line up the holes. NOTE:
Coupler Plate must line up with the round holes and not the
oval holes.
3. Position one of the Brackets as shown in figure 3. The
bracket should be bolted to the Coupler Plate so that it runs
horizontal when the tripod is sitting upright.
4. Use one
2 3/4" bolt and lock nut
Bracket and Coupler Plate.
2
5. Position the 12' Ladder Assembly as shown in figure 4.
6. Slide the Assembly into the Coupler Plate and secure
with one,
2 3/4" bolt and lock nut.
4
2 3/4" BOLT, LOCK NUT -
6
WRENCH TIGHTEN
to secure both the
COUPLER PLATE
(PN 14061.300)
(see figure 5)
12' LADDER
ASSEMBLY
(PN 14063.1100)
COUPLER PLATE
(PN 14061.300)
BRACKET
(PN 14061.400)
1
2 3/4" BOLT, LOCK NUT -
3
WRENCH TIGHTEN
2 3/4" BOLT, LOCK NUT -
WRENCH TIGHTEN
5
7. Carefully rotate the tripod assembly to gain access to one
of the legs.
8. Slide another Coupler Plate on the Leg and line up the
round holes as shown in figure 6.
9. Position one Bracket as shown in figure 6 and secure
using one
2 3/4" bolt and lock nut.
BRACKET
(PN 14061.400)
PG 3