Kohler K-1142 Kurulum Kılavuzu - Sayfa 7
Küvetler Kohler K-1142 için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. Kohler K-1142 25 sayfaları. Drop-in acrylic baths
Ayrıca Kohler K-1142 için: Kurulum Kılavuzu (25 sayfalar), Kurulum ve Bakım Kılavuzu (29 sayfalar), Kurulum ve Bakım Kılavuzu (25 sayfalar)
Sayfayı Yazdır
Water-Resistant
Wall Material
Bath
7. Complete the Installation
If used, install the optional apron at this time according to the instructions (only applies to select
models) packed with the apron.
Carefully remove the protective tape from the bath rim.
Apply a bead of silicone sealant to the nailing-in flange.
Install water-resistant wall material a maximum of 1/4" (6 mm) above the bath deck.
Seal the joints between the bath rim edges and the water-resistant wall material with silicone
sealant. Tape and mud the water-resistant wall material.
Install the finished wall. Seal the joints between the bath rim and the finished wall with silicone
sealant.
Install the faucet trim according to the faucet manufacturer's instructions.
Clean-Up
When cleaning up after installation, do not use abrasive cleaners, as they may scratch and dull the bath
surface. Use warm water and a liquid, non-abrasive detergent to clean the surface.
CAUTION: Risk of product damage. Do not allow cleaners containing petroleum distillates to remain
in contact with the surface for long periods of time.
Remove stubborn stains, paint, or tar with turpentine or paint thinner. Remove plaster by scraping with a
wood edge. Do not use metal scrapers, wire brushes, or other metal tools. You can use a powder-type
detergent on a damp cloth to provide mild abrasive action to any residual plaster.
Kohler Co.
Framing
Finished
Wall
Apply silicone
sealant to the
joint between the
bath and the
finished wall
7
1016757-2-C