Kohler WELLWORTH LITE K-3414-PB Kurulum Talimatları Kılavuzu - Sayfa 4

Tuvaletler Kohler WELLWORTH LITE K-3414-PB için çevrimiçi göz atın veya pdf Kurulum Talimatları Kılavuzu indirin. Kohler WELLWORTH LITE K-3414-PB 8 sayfaları. Vitreous china reverse trap toilet

Sayfayı Yazdır

TO INSTALL NEW TOILET

Place new toilet upside down on padding. Firmly place

gasket on toilet outlet.

NOTE: If using gasket with integral plastic sleeve, make

sure the gasket is positioned facing away from the toilet.

Remove rag from closet flange before setting toilet.

Carefully align and lower toilet over the closet flange and

bolts.

CAUTION: Do not lift or rock toilet after placement;

a new gasket must be reapplied if you break the

watertight seal.

Apply full body weight to toilet rim to set seal.

Assemble bolt cap bases, washers, and nuts on exposed

T-bolts. Hand-tighten nuts, then tighten additional 1/2-turn

with wrench.

CAUTION: Overtightening may cause breakage

or chipping.

If T-bolts extend more than 1/4" from top of nut, cut off ex-

cess. Wipe away any residue. Install bolt caps.

TO INSTALL NEW TANK

Make sure the three tank bolts extend fully through the

holes in the gasket. Set the tank onto the bowl using the

bolts as a guide. Center the gasket on the inlet of the bowl.

Assemble the washers and brass hex nuts onto the bolts.

CAUTION: Overtightening may cause breakage

or chipping.

Alternately tighten the three brass hex nuts so that the top

of the tank is level with the top of the bowl and a watertight

seal is obtained.

111784-2-

(9412)

Toilet Outlet

Gasket

Bolt Cap

Nut

Washer

Bolt Cap Base

Tank Bolt

Washer

Nut

Fig. #5

Fig. #6

Gasket

Fig. #7

Kohler Co., Kohler, WI