Kohler WELLWORTH LITE K-3414-PB Kurulum Talimatları Kılavuzu - Sayfa 5

Tuvaletler Kohler WELLWORTH LITE K-3414-PB için çevrimiçi göz atın veya pdf Kurulum Talimatları Kılavuzu indirin. Kohler WELLWORTH LITE K-3414-PB 8 sayfaları. Vitreous china reverse trap toilet

Sayfayı Yazdır

TO CONNECT WATER SUPPLY

NOTICE: Read carefully before performing this step.

For supply installation, refer to instructions packed with

shut-off valve. Carefully bend tubing to fit.

Cut tubing end 1/4" longer than distance between shut-off

valve and supply shank. Remove any burrs from inside of

tube.

Slip coupling nut, compression nut, and ferrule onto

tubing. Insert tubing into shut-off valve and supply shank,

positioning seal washer (supplied) or compression

washer (not supplied) as shown. Hand-tighten coupling

nut and then tighten compression nut.

WARNING: Do not over–tighten or you may

deform connections and cause a leak. Do not use

tools to tighten plastic nuts.

Turn shut-off valve on and check for leaks. If connections

are squarely assembled, a slight retightening of the nuts

will stop any leaks.

If toilet is leaking in between the tank and bowl, carefully

retighten the three tank bolts evenly. Check all bowl and

tank connections for leaks for several days.

Hold float under water for a few seconds to fill ballast.

Adjust float by sliding it up or down on float rod until water

level is at the marked water line on the flush valve over-

flow.

Check all connections for leaks for several days.

WARNING: Risk of personal injury or property

damage. Do not flush toilet with float valve cap

removed. Pressurized water will spray upward and

may cause water damage or injury.

Kohler Co., Kohler, WI

Supply Shank

Seal Washer

Tubing

Coupling Nut

Compression Nut

Ferrule

Shut-Off Valve

Fig. #8

Float

Fig. #10

Supply Shank

Compression Washer

Tubing

Coupling Nut

Compression Nut

Ferrule

Shut-Off Valve

Fig. #9

Float Rod

111784-2-

(9412)