AQC MAXIVIBE AMV-450 Kullanıcı El Kitabı - Sayfa 13

Toz Toplayıcı AQC MAXIVIBE AMV-450 için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. AQC MAXIVIBE AMV-450 20 sayfaları.

Shaker type dust collector

13.4

Anchors

All sections of the collector should be firmly anchored to a cement slab in order to prevent tipping

of the unit should an explosion occur or due to extreme winds.

13.5

Interior installation

When a dust collector is installed inside of a building, the collector should be installed within 10

feet of an exterior wall and be connected to a vent duct connected to the exterior of the building.

This vent duct system should possess the same pressure capabilities of the collector.

If the filtered air coming from the collector is recycled back into the building, certain precautions

should be taken in order to exhaust the air outside of the building in the event a filter inside the

collector should fail in its performance or other performance deficiency. A secondary filtration

system should be considered to protect staff or personnel within the building. Bursts of air

exhausted out of the collector or of the explosion vent should be directed out of the way of

pedestrian walkways, parking lots, offices or any other area where people could have access.

13.6

Processes creating sparks

If dusts or collected matter is present in the collector or in the equipment connected to the

collector, no activity that could create sparks such as welding should take place until the system

has been shut down and thoroughly cleaned. If similar operations should be performed in the area

of the filter envelope, such filter should be removed and stored in a dry area.

A scheduled preventive maintenance program will reduce downtime situations and increase

lifetime of the unit. Charts shown in this chapter refer to maintenance and procedures related

in solving malfunction. Timers and delays may be modified with conclusive experimenting of the

system on a particular application.

14.1

Replacing the filter envelope

The lifetime of the filter envelope is directly linked to its resistance to the dust filtered and does not

necessarily require a regular filter replacement. However, if the filter envelope is torn or punctured,

it needs to be replaced as soon as as possible.

Refer to the Safety measures section before proceeding with

the inspection or maintenance of the dust collector.

WARNING!