AQTRONIC SF53 Kullanım Kılavuzu - Sayfa 4

Kontrolör AQTRONIC SF53 için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. AQTRONIC SF53 5 sayfaları.

SF53

CNC PLASMA Torch Height Controller

"HYS" (Hysteresis see image 15 page 5) - The hystere-

sis voltage - a range in which the voltage is measured,

in which there are signals controlling UP/DOWN is

deactive.1-15V.Factory setting "1"

"dLy" (delay) - delay time of output OK when the sys-

tem detects the main (cutting) arc

1 - 15 seconds. factory setting: 1s

"CAL" (Calibration) - Due to material deviation the

recorded plasma voltage may need adjustment.

According to an external reference, such as the simple

voltmeter, you can modify the Plasma voltage reading.

-35V to +35V.Factory 0V

"LCU" (Low Voltage cut) - value of the off load voltage

detection in the plasma cutter - used to detect the

main (cutting) arc.Minus the preset value any control

outputs are disable.0-99V.Factory 40V

"HCU" (High Voltage cut) - value of the off load voltage

detection in the plasma cutter - used to detect the

main (cutting) arc.Over the preset value any control

outputs are disable.200-350V.Factory 350V

"tSt" (Test) - Simulation of the controller's work - the

system simulates the appearance of "floating" Torch

within a countdown timer.By pressing any keys you

can exit from test mode or just wait a few seconds for

auto exit.

"ESC" (Escape) - by pressing the up/down keys you

can exit of menu or just wait a few seconds for auto

exit.

http://www.aqtronic.com