Aqua Creek TIDAL WAVE F-TWPB-06 Manuel - Sayfa 5

Fitness Ekipmanları Aqua Creek TIDAL WAVE F-TWPB-06 için çevrimiçi göz atın veya pdf Manuel indirin. Aqua Creek TIDAL WAVE F-TWPB-06 14 sayfaları.

TOOLS REQUIRED
1/2" SOCKET
5.
Attach the pedal assemblies to the
main frame with two (2) 5/16" x 3/4" hex
head bolts, 5/16" lock washers and 5/16"
fl at washers (this hardware is already
pre-installed on the bike).
See FIG. 5 to the right.
NOTES: Viewing from as if sitting on
the bike, be sure the right pedal is
being installed on the right side of the
bike and left pedal on the left side of
the bike! Installing them backwards
could lead to the pedals unthreading
and breaking off !
Be sure the pedals are opposite each
other! If the left pedal is all the way
up, the right pedal should be all the
way down!
6.
Attach the seat to the main frame
using the quick adjustment knob. The
seat has 5 height adjustment holes, in
1" increments.
See FIG. 6 to the right.
NOTE: It is easiest to set seat height,
handlebar location and foot strap
tightness BEFORE placing the bike in
the water. Before riding, always check
that the seat post is securely clamped.
Riding with an improperly tightened
seat post can allow the saddle to slip
and/or fall.
Copyright © 2019 Aqua Creek Products All Rights Reserved
Tidalwave Assembly Instructions
MAIN FRAME

RIGHT PEDAL

ASSEMBLY
FIGURE 5
MAIN FRAME

LEFT PEDAL

ASSEMBLY
5/16" X 3/4"
HEX HEAD (2)
5/16" LOCK
WASHER (2)
5/16" FLAT
WASHER (2)
ADJUSTABLE
SEAT
QUICK
ADJUSTMENT
KNOB
FIGURE 6
5
Revised 10/30/19