Aqua Creek Products Cycle Attachment Hızlı Başlangıç Kılavuzu - Sayfa 3
Aydınlatma Ekipmanları Aqua Creek Products Cycle Attachment için çevrimiçi göz atın veya pdf Hızlı Başlangıç Kılavuzu indirin. Aqua Creek Products Cycle Attachment 8 sayfaları.
Sayfayı Yazdır
ASSEMBLY INSTRUCTIONS: CYCLE ATTACHMENT
The Cycle Attachment will work on any standard Aqua Creek Products chair assembly. Shown
above is the Cycle Attachment being installed on the Pro Pool lift. The Cycle Attachment
Armrests require removing the existing armrests for installation.
STEP 1: R e m o v e t h e ¼ " x 3 " b u t t o n -head screws, washers and nuts. Remove the existing
armrests from the chair. Replace with the Cycle Attachment Armrests (FIGURE 3-A, next
page). Make sure the handgrips are facing upwards.
STEP 2: R e i n s t a l l t h e ¼ " b u t t o n -head screws and hardware. Tighten until snug.
STEP 3: R e m o v e t h e 2 " s q u a r e p l a s t i c e n d -cap from the front of the chair-support tube (front
of chair between legs, see next page FIGURE 3-B).
STEP 4: Remove the 5/16" x 4 " h e x b o l t a n d a s s o c i a t e d h a r d w a r e from under the seat (see next
page, FIGURE 3-B).
STEP 5: Slide the Bike-Pedal Attachment into the chair-support tube. Press the CA-SLEEVE
into the seat-tube until it is fully seated (FIGURE 3-B, next page). Align one of the leg-length
adjustment holes with the holes through the chair and the chair-support tube (FIGURE 3-B,
next page).
STEP 6: Install 5 / 1 6 " s p ring-pin into aligned holes, and clip the spring over the end.
The Cycle Attachment is now ready for use.
3