Aqua Creek Products F-044SCH Talimatlar Kılavuzu - Sayfa 2
Akü Şarj Cihazı Aqua Creek Products F-044SCH için çevrimiçi göz atın veya pdf Talimatlar Kılavuzu indirin. Aqua Creek Products F-044SCH 16 sayfaları. 24v solar charger
Sayfayı Yazdır
BATTERY CABLE
CONNECT TUBE
LOWER MAST
BATTERY CABLE
CHARGE CONNECTOR
To assemble the Solar Charger you will need two (2) 7/16" wrenches or sockets and a 5/32" allen key.
The 24V Solar-Charger comes fully wired, in two halves for shipping. To assemble the charger remove it
from the shipping box and connect the UPPER MAST to the LOWER MAST by fl ipping the UPPER MAST up
and sliding the CONNECT TUBE inside the UPPER MAST and aligning the holes as shown above. Pull the
BATTERY CABLE and the CHARGE CONNECTOR through the tube as you slide the TOP ASSEMBLY down.
DO NOT PINCH THE BATTERY CABLE! Install the supplied 1/4" x 1 1/2" button head bolt, the fl at washers
and Nylock-nut as shown. Tighten until snug.
Next, fl ip-up the SOLAR PANEL ASSEMBLY until it is fl at-horizontal, and install the 1/4" x 1 3/4" hex bolt
and fl at washer underneath as shown. Install the 2nd fl at washer and the Nylock nut on the opposite
side, and tighten until snug. The Solar Charger is now ready to install on your pool lift.
2
Copyright © 2017 Aqua Creek Products All Rights Reserved
Unpacking and Assembly
1/4" NYLOCK
NUT
1/4" FLAT
WASHER (2)
1/4" X 1-3/4"
HEX BOLT
UPPER MAST
UPPER MAST
1/4" NYLOCK
NUT
1/4" FLAT
WASHER (2)
1/4"-20 X 1 1/2"
BUTTON HEAD
W/ SLEEVE SHRINK
SOLAR-PANEL
ASSEMBLY
BATTERY CABLE
CHARGE CONNECTOR
SOLAR PANEL
ASSEMBLY
FLIP-UP
SOLAR CHARGE
CONTROLLER
FLIP UP
BATTERY CABLE
DO NOT PINCH!
CONNECT
TUBE
LOWER MAST
MOUNTING POST
(
1/2"-13 THREAD)
Revised 12/4/17