Aqua Lights AL250MH Kurulum ve Bakım Talimat Kılavuzu - Sayfa 7
Işık Fikstürü Aqua Lights AL250MH için çevrimiçi göz atın veya pdf Kurulum ve Bakım Talimat Kılavuzu indirin. Aqua Lights AL250MH 14 sayfaları. Underwater hull light
Sayfayı Yazdır3. Apply epoxy to dry:
• Clean core material, leaving no visible core.
• Fill it to an even level amount.
• Sand clean and inspect for bubbles or pin holes.
4. There is an O-ring supplied with the
light to be used when installing on
smooth level surfaces of fiberglass or
metal.
• If the surface is irregular, disregard the O-ring.
• The surface should be clean of debris and moisture at this time, and
you should use the 180-grit sand paper to rough the adhesion points.
• Apply a generous amount of 3M 5200 Marine Adhesive Sealant.
• A 1/2-inch bead completely around the flange and some on the
shaft of the light will be sufficient.