DFA SqwidNET Visio Tamper Kurulum Kılavuzu - Sayfa 6

Güvenlik Sensörleri DFA SqwidNET Visio Tamper için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. DFA SqwidNET Visio Tamper 13 sayfaları. Manhole tampering solution

Sayfayı Yazdır

Fig. 3.1

Fig. 3.4

3. Device Preparation

Step 1: Open the device

Instructions:

1. Unscrew the two back screws using a star (Phillips)

screwdriver.

2.Remove the back cover from the end where the

screws are located and gently lift it up. If necessary, use a

screwdriver to carefully pry open the enclosure once the

screws have been removed.

Fig. 3.2

Step 2: Plug in the power connector

Instructions:

1. Take care to maintain the original orientation of the back

cover to the enclosure.

2. Plug the 2-pin power plug into the board connector. The

green LED on the board will ﬂash temporarily once power has

been successfully connected.

Fig. 3.5

Fig. 3.3