Aqua Medic CO2 complet Kullanım Kılavuzu - Sayfa 4

Evcil Hayvan Bakım Ürünü Aqua Medic CO2 complet için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Aqua Medic CO2 complet 8 sayfaları.

Sayfayı Yazdır
Adjustion
1. Open the needle valve (3) slightly
2. Open the valve at the CO
70 bars, the working pressure gauge 1.5 bar ( 1-2 bar).
3. Open the needle valve, until the desired number of bubbles is reached.
Bubble counter: The exact control of the flow rate is checked with the bubble counter.
Safety tips
- Never separate a stationary pressure regulator form a CO
the bottle valve, and open the needle valve to release the gas befor you separate both units.
Keep all CO
pressure bottles away from heat.
2
3. CO
reactor 500
2
Use this reactor to replace CO
underwater operation only. Read and follow all instructions in this leaflet carefully for best results.
fig 2: reactor
1. CO
- reactor
2
2. flow adjustion valve
3. rubber sucker
4. lid with inner pipe
5. bottom lid
6. spiral tube
7. closing cap
8. water connection
9. CO
connection
2
10. spare port
11. adjudtion valve
technical characteristics
unit
art no:
CO
- connection port:
2
CO
input tube connection
2
water flow
holding system
The unit is designed for aquariums up to 500 l ( 120 gal) and
10°KH (4 mmol alcalinity). It can be increased with up to 4
enlargements. Each enlagrement will increase the capacity for
300 l (80 gal).
4
bottle (four full turns). The primary pressure gauge shows now 60 -
2
loss in freshwater or saltwater. This reactor has been designed for
2
CO
2
71111
9 mm
6 /4 mm, (1/4")
min 500l/h ( 125 gph),
max 1000 l/h (250 gph)
rubber sucker
bottle, if it is under pressure. Close
2