AVR Cinema Mirror HC 37.53 Kurulum İçin Talimatlar ve İpuçları - Sayfa 7

Projektör Aksesuarları AVR Cinema Mirror HC 37.53 için çevrimiçi göz atın veya pdf Kurulum İçin Talimatlar ve İpuçları indirin. AVR Cinema Mirror HC 37.53 9 sayfaları.

Sayfayı Yazdır

figure 7A

figure 7B

INSTRUCTIONS AND TIPS FOR THE INSTALLATION

OF THE HC 37.53 MODEL CINEMA MIRROR

GENERAL RECOMMENDATIONS FOR ASSEMBLY AND INSTALLATION

HOW TO ADJUST THE

IMAGE TO THE SCREEN

ATTENTION – DANGER !!

Take out he rubber that blocks the door

during the transport (if you have not already

made it), before triggering the movement

pushbutton of the active mirror gate, make

sure that there are no obstacles hindering

its opening or closing. Do not make any effort

to stop or help the active mirror gate in its

path, the mechanics of the motor can be

seriously damaged and the warranty of the

product will be lost.

If you observe any defect, this may be due

to the handling or lack of care during

transport of Cinema Mirror. Contact your

distributor's technical service.

Activate the button for opening or closing

(not included) on the Cinema Mirror. The

motor of the active mirror will be put into

operation.

Remove the film that protects the optic

mirrors during transport and pre-installation.

Switch on the projector and wait a few

minutes so that the projector reaches its

maximum brightness.

The light or image thrown by the projector

through the active mirror determines the

place where the projection screen should

be installed.

Remember that you can work on the

projector zoom to fix the screen width.

Install the projection screen guided by the

light spectrum thrown by the projector. If

you use a screen with black side margins,

the image will be better profiled; as television

sets do in their cathode ray tubes.

INSERT A VIDEO OR PC SIGNAL IN

THE INSTALLED PROJECTOR

The control lever of red color regulates the

position and opening of the active mirror

(Fig. 3 detail 2) and consequently, the

projection height on the screen.

· Place the control lever on the upper part.

· Activate the motor with the installed push-

button.

· Observe the image that is projected on the

screen. To lower the image the control lever

should be moved downward. The motor

actives and positions the active door as

desired.

· Repeat this operation until reaching the

desired image height.

ATTENTION.

If the whole image is not represented on the

projection screen, this may be due to the fact

that:

• The projector zoom is closed.

• The projector is very near the passive mirror.

• The active mirror is excessively closed.

Correct these differences.

The image may not be parallel with the

projection screen base due to height

differences between the place of installation

of the screen and that of the projector (Fig.

7A).

In the connecting rods that move the active

mirror, (Fig 3 detail 8) there is a connecting

rod-active mirror regulation screw that

corrects the defect. If you want to lift the image,

move the connecting rod screw of the place

affected upwards. (Fig. 7B)

Remember the adjustment elements that you

have to obtain a cinema image.

1. - Projector zoom and focus.

2. - Vertically adjustable feet, in the projector.

3. - Trapeze correction, manual, automatic or

electronic, in the projector.

4. - Passive mirror turn.

5. - Active mirror movement

6. - Horizontal image control in the connecting

rods.

7. - Left / right movement of the projection

screen (only some makers)

8. - Regulation of the height extension of the

projection screen.