AVR Cinema Mirror HC 37.53 Kurulum İçin Talimatlar ve İpuçları - Sayfa 8

Projektör Aksesuarları AVR Cinema Mirror HC 37.53 için çevrimiçi göz atın veya pdf Kurulum İçin Talimatlar ve İpuçları indirin. AVR Cinema Mirror HC 37.53 9 sayfaları.

Sayfayı Yazdır

figure 8

INSTRUCTIONS AND TIPS FOR THE INSTALLATION

OF THE HC 37.53 MODEL CINEMA MIRROR

GENERAL RECOMMENDATIONS FOR ASSEMBLY AND INSTALLATION

FINAL FINISH OF THE CEILING

Once we are definitively satisfied with the

image obtained, we will proceed to close the

ceiling with the same material used by the

maker of the technical ceiling. If you use

other materials, try to use materials with a

very low weight. Consult the possibilities of

painting or masking of the material used for

a correct simulation with the original ceiling.

ATTENTION PLEASE!

(active door) is not prepared to carry heavy

loads, as for example, parts in wood, cork,

glass, etc., that one might want to install on

the door as decoration items.

If you desire this, try to modify the finish, by

painting or imitating the painting by means

of a very thin foil, to be able to integrate the

finish of the door of the Cinema Mirror to

the roof decoration in which it is installed.

Take the measurements in which the gate

was located with the frame, measurements

A and B (Fig 8). Mark the measurements A

and B on the technical ceiling plate

(60x60cm), (or replacement material).

Place the bevel on the marks A and B, and

draw the contour lines. With a cutting tool

remove the space that must be occupied by

the gate.

The installer should locate his working

position in the square of the technical ceiling

plate, adjacent to the Cinema Mirror

installation.

The motor system

Move the Cinema Mirror-projector set as

much as is necessary to install the modified

technical plate.

Place the Cinema Mirror-projector set in the

space chosen.

Lightly press the bevel pins outwards and

adjust them to the gate.

Check the light-image on the screen.

Provide the finishing touches to the ceiling

finish according to the characteristic

requirements of the space.

MAINTENANCE

The mechanics and mobile parts of the

equipment don't specify of a severe

maintenance, but if it is convenient the

application of a lubricant in the mobile parts,

with a minimum periodicity of 90 days.

Revise the electric installation and its

connections, likewise revise the anchorage

from the unit to the roof.

The optic lenses will clean with non abrasive

cloths, using neuter soaps or simply with

common water.