DFRobot Beetle Shield Hızlı Başlangıç Kılavuzu - Sayfa 2

Anakart DFRobot Beetle Shield için çevrimiçi göz atın veya pdf Hızlı Başlangıç Kılavuzu indirin. DFRobot Beetle Shield 4 sayfaları.

Specification



Operating voltage: 3 - 5V



Compatible with DFRobot Beetle

Attaching the Beetle controller to the Beetle shield

Note: For Beetle shield versions lower than v1.1 the label for D9 and D11 is switched. The pin

labeled with D9 on the shield goes to D11 on the Beetle and D11 on the shield is going to D9 on the

Beetle. Please take the labels on the Beetle controller as the right ones. We have fixed this error in

v1.1

To attach the Beetle to the shield it requires some soldering work. Align the holes of the Beetle with

the pins on the shield. Make sure the Beetle controller is showing the microcontroller chip and the

USB socket facing up to ensure the correct polarity and pin assignment after soldering it to the

shield.

Beetle controller on Beetle shield (click to enlarge)

Push the Beetle down onto the pins and let the pins looking out for ca. 1mm. Solder the eight pins at

the pads of the Beetle using a soldering iron or soldering gun.

Soldering the Beetle controller on the Beetle shield