DG USB3D-IP Manuel - Sayfa 10
Anakart DG USB3D-IP için çevrimiçi göz atın veya pdf Manuel indirin. DG USB3D-IP 16 sayfaları. Usb3.0 device function ip-core
Sayfayı Yazdır
dg_usb3.0_dev_ip_demo_instruction_en.doc
Power up all demo device, run serial terminal (TeraTerm for example) and set following
•
communication parameter
Baud Rate = 115,200
a) Start iMPACT and download evaluation bit-file to FPGA.
•
b) For ZC706 board only, set SW11="00000" to configure PS from JTAG, and set SW4="01" to connect
JTAG to USB-to-JTAG interface, as shown in Figure 14 and Figure 15. After that, open ISE
command prompt and run bat file to download bit-file and elf-file to FPGA, as shown in Figure 16.
15 May 2015
Figure 13
Figure
13: Adapter board connection to ZC706
: Adapter board connection to ZC706
Figure
Figure
13
13
: Adapter board connection to ZC706
: Adapter board connection to ZC706
Data = 8bit
Figure 14
Figure
14: SW11 setting on ZC706 board
: SW11 setting on ZC706 board
Figure
Figure
14
14
: SW11 setting on ZC706 board
: SW11 setting on ZC706 board
Figure 15
Figure
15: SW4 setting on ZC706 board
: SW4 setting on ZC706 board
Figure
Figure
15
15
: SW4 setting on ZC706 board
: SW4 setting on ZC706 board
Stop Bit = 1
Parity = None
Page 10