Avtech Ezum DGC1304-10 Kullanıcı Kılavuzu - Sayfa 4
Güvenlik Kamerası Avtech Ezum DGC1304-10 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Avtech Ezum DGC1304-10 8 sayfaları. Ir dome camera
Sayfayı Yazdır
CONNECTION
1. DC12V Input Terminal
Connect the power terminal of the camera to a DC 12V regulated power supply.
Note: Please use the correct power adaptor, DC12V (regulated), to operate this unit. The power
tolerance of this unit is DC12V ± 10%. Over maximum DC 12V power input will damage this
unit.
2. Video Output Connector (VIDEO OUT)
Connect the camera video output to the video input of a DVR with 75Ω coaxial cable.
Note: To ensure the camera has sufficient protection against moisture, an extra waterproof
measure, such as by using an insulating tape, must be used to cover the power and video
connectors after connection.
FOCAL LENGTH & FOCUS ADJUSTMENT
This camera supports remote focal length and focal adjustment remotely from our HD CCTV DVR.
On the DVR live view, click the channel which connects this camera to display in the full screen mode, and
select
to show the PTZ control panel:
＋
－
/
Zoom in / out max
Zoom in / out
/
Focus near / far
/
IR intensity
IR LED BRIGHTNESS CONTROL (PWM)
This function is used to control the brightness of IR LEDs. The brightness is set to the maximum by default.
Note: This function shows only on our brand's HD CCTV DVR with specific firmware version. If you
don't see this option, try upgrading your DVR or check with your installer.
For example, if you feel the image is too bright when the night mode is on, resulting a little bit overexposure,
you can use this function to modify as you wish.
On the DVR live view, right click to show the DVR main menu, and select ADVANCED CONFIG
DCCS DCCS MENU.
ADVANCED CONFIG
CAMERA
DETECTION
ALERT
NETWORK
DISPLAY
RECORD
DCCS
NOTIFY
EXIT
In DCCS SETUP, click the value to change it from 0 ~ 100.
DCCS SETUP
IR1 BRIGHTNESS USER 1
IR1 BRIGHTNESS USER 2
Click to zoom in on the image to the largest / zoom out on the image to its
original size.
Click to zoom in / out the image.
Click to adjust the focus of the image.
Click and drag the slider from 0 ~ 5 to adjust the brightness level in the dark
environment. The higher the value, the brighter the image.
CH1
CH2
CH3
CH4
OSD MENU
SETUP
DCCS MENU
SETUP
F.W.
E8
DEVICE
AVT SERIES
CONNECTION
OK
100
100