Avtech Ezum DGC1304-10 Panduan Pengguna - Halaman 4

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Kamera Keamanan Avtech Ezum DGC1304-10. Avtech Ezum DGC1304-10 8 halaman. Ir dome camera

Halaman Cetak

CONNECTION

1. DC12V Input Terminal

Connect the power terminal of the camera to a DC 12V regulated power supply.

Note: Please use the correct power adaptor, DC12V (regulated), to operate this unit. The power

tolerance of this unit is DC12V ± 10%. Over maximum DC 12V power input will damage this

unit.

2. Video Output Connector (VIDEO OUT)

Connect the camera video output to the video input of a DVR with 75Ω coaxial cable.

Note: To ensure the camera has sufficient protection against moisture, an extra waterproof

measure, such as by using an insulating tape, must be used to cover the power and video

connectors after connection.

FOCAL LENGTH & FOCUS ADJUSTMENT

This camera supports remote focal length and focal adjustment remotely from our HD CCTV DVR.

On the DVR live view, click the channel which connects this camera to display in the full screen mode, and

select

to show the PTZ control panel:

＋

－

Zoom in / out max

Zoom in / out

Focus near / far

IR intensity

IR LED BRIGHTNESS CONTROL (PWM)

This function is used to control the brightness of IR LEDs. The brightness is set to the maximum by default.

Note: This function shows only on our brand's HD CCTV DVR with specific firmware version. If you

don't see this option, try upgrading your DVR or check with your installer.

For example, if you feel the image is too bright when the night mode is on, resulting a little bit overexposure,

you can use this function to modify as you wish.

On the DVR live view, right click to show the DVR main menu, and select ADVANCED CONFIG 

DCCS  DCCS MENU.

ADVANCED CONFIG

CAMERA

DETECTION

ALERT

NETWORK

DISPLAY

RECORD

DCCS

NOTIFY

EXIT

In DCCS SETUP, click the value to change it from 0 ~ 100.

DCCS SETUP

IR1 BRIGHTNESS USER 1

IR1 BRIGHTNESS USER 2

Click to zoom in on the image to the largest / zoom out on the image to its

original size.

Click to zoom in / out the image.

Click to adjust the focus of the image.

Click and drag the slider from 0 ~ 5 to adjust the brightness level in the dark

environment. The higher the value, the brighter the image.

CH1

CH2

CH3

CH4

OSD MENU

SETUP

DCCS MENU

SETUP

F.W.

DEVICE

AVT SERIES

CONNECTION

100