Dell Inspiron 2100 Sistem Referans Kılavuzu - Sayfa 24

Dizüstü Bilgisayar Dell Inspiron 2100 için çevrimiçi göz atın veya pdf Sistem Referans Kılavuzu indirin. Dell Inspiron 2100 45 sayfaları. Vga card installation instructions
Ayrıca Dell Inspiron 2100 için: Buradan başlayın (2 sayfalar), Kurulum ve Özellik Bilgileri (8 sayfalar), Hızlı Referans Kılavuzu (17 sayfalar), Servis Kılavuzu (38 sayfalar), Teknik Özellikler (2 sayfalar), Kurulum Talimatları (1 sayfalar)

microprocessor socket, you do not need to use force, which could bend the pins if the chip is misaligned. When the chip is

positioned correctly, press it with minimal pressure to seat the microprocessor in the socket. Be careful not to bend the pins.

d. When the chip is fully seated in the socket, pivot the microprocessor-socket release lever back toward the socket until it snaps

into place, securing the chip.

Battery

CAUTION: There is a danger of the new battery exploding if it is incorrectly installed. Replace the battery only with the same or

equivalent type recommended by the manufacturer. Discard used batteries according to the manufacturer's instructions.

To remove the 3-volt (V), CR2032 coin-cell battery:

1. Make a copy of the screens in the system setup program. Enter the

copy the system configuration information from the system setup screens.

Remove the computer

cover.

Rotate the power

supply.

4. Pry the battery out of its socket with your fingers or with a blunt, nonconductive object such as a plastic screwdriver.

To replace the battery:

1. Install the new battery with the "+" side facing up.

2. Rotate the power supply back into place, replace the computer cover, and reconnect your computer and devices to their electrical outlets and

turn them on.

3. Reboot the computer, press <Del> when the blue Dell logo screen appears to enter the system setup program, and restore the correct

settings.

System Board

1 Battery

2 Battery socket

system setup

program, and print (by pressing the <Print Screen> key) or