DH Instruments 3367797 Talimat Sayfası - Sayfa 2

Kablolar ve konektörler DH Instruments 3367797 için çevrimiçi göz atın veya pdf Talimat Sayfası indirin. DH Instruments 3367797 2 sayfaları. Interconnection kit for mpg2-h with rpm4 or pg7302

Sayfayı Yazdır

wrap Teflon

thread tape around the NPT threads

three times and install it into the DUT.

Install the Device Under Test (DUT). The DUT will

be connected to the test line with the remaining

flexible 5 in. nipple. This nipple can be installed either

in the 3-way tee, or in the port on top of the MPG2-H.

The tube can be slightly bent if necessary. Install the

nipple in the desired location. Tighten the gland in the

tee or MPG2-H, but do not tighten the gland that

connects to the DUT.

Plug the open test port: There is an open test port

either on the top of the MPG2-H, or on the 3-way

tee. Insert the stainless steel plug into a gland.

Insert the plug and gland into the open port. Do not

tighten.

Prime the system, tighten fittings: Pump fluid

through the nipples by using the MPG2-H. See

the appropriate section of the MPG2-H Operation

and Maintenance Manual for this procedure.

Make sure that all air is purged from the test lines.

There are 3 loose fittings: one on the DUT, one on

the RPM4 or PG7302, and the other on the plug.

Tighten each of the loose fittings when oil without

bubbles begins to flow through it.

t 3367676

Documen

DH Instruments,

a Fluke Company

4765 East Beautiful Lane

Phoenix AZ 85044-5318

USA

Figure 1: Nipples installed in 3-way tee, elbow and union

W Warning

• The maximum operating pressure of

the variable volume is

(15,000 psi) in MPG2-H-HV and 200

MPa (30,000 psi) in MPG2-H. Do not

generate pressure greater than the

maximum operating pressure.

• High pressure fluids are potentially

hazardous.

Energy

pressurized fluids can be released

unexpectedly and with extreme force.

High pressure systems should be

assembled and operated only by

personnel who have been instructed

in proper safety practices.

• ALWAYS use external tubing and

fittings rated for pressures equal to

greater

than

pressure which MPG2-H will be used

to generate.

100 MPa

stored

the

maximum

081001

Tel 602.431.9100

Fax 602.431.9559

[email protected]