Dell E74S001 Referans Kılavuzu - Sayfa 16

Sunucu Dell E74S001 için çevrimiçi göz atın veya pdf Referans Kılavuzu indirin. Dell E74S001 25 sayfaları.

Sayfayı Yazdır

Table 16. Integrated Devices details (continued)

Option

Serial Communication

To view the Serial Communication screen, power on the system, press F2, and click System Setup Main Menu > System

BIOS > Serial Communication.

NOTE:

The serial port is optional for the PowerEdge R650xs system. The Serial Communication option is applicable only if

the serial COM port is installed in the system.

Table 17. Serial Communication details

Option

Serial Communication

Serial Port Address

External Serial Connector

Failsafe Baud Rate

Remote Terminal Type

Pre-operating system management applications

Description

NOTE:

The slot bifurcation supports on PCIe slot only, does not support

slot type from Paddle card to Riser and Slimline connector to Riser.

Description

Enables the serial communication options. Selects serial communication

devices (Serial Device 1 and Serial Device 2) in BIOS. BIOS console redirection

can also be enabled, and the port address can be specified.

The options available for System without serial COM port (DB9) are On

without Console Redirection, On with Console Redirection, Off. This

option is set to Off by default.

The options available for System with serial COM port (DB9) are On without

Console Redirection, On with Console Redirection via Com1, On with

Console Redirection via Com2, Off, Auto. This option is set to Auto by

default.

Enables you to set the port address for serial devices. This option is set to

Serial Device1=COM2, Serial Device 2=COM1 by default.

NOTE:

You can use only Serial Device 2 for the Serial Over LAN (SOL)

feature. To use console redirection by SOL, configure the same port

address for console redirection and the serial device.

NOTE:

Every time the system boots, the BIOS syncs the serial MUX

setting that is saved in iDRAC. The serial MUX setting can independently

be changed in iDRAC. Loading the BIOS default settings from within the

BIOS setup utility may not always revert the serial MUX setting to the

default setting of Serial Device 1.

Enables you to associate the External Serial Connector to Serial Device 1,

Serial Device 2, or the Remote Access Device by using this option. This

option is set to Serial Device 1 by default.

NOTE:

Only Serial Device 2 can be used for Serial Over LAN (SOL).

To use console redirection by SOL, configure the same port address for

console redirection and the serial device.

NOTE:

Every time the system boots, the BIOS syncs the serial MUX

setting saved in iDRAC. The serial MUX setting can independently be

changed in iDRAC. Loading the BIOS default settings from within the BIOS

setup utility may not always revert this setting to the default setting of

Serial Device 1.

Specifies the failsafe baud rate for console redirection. The BIOS attempts to

determine the baud rate automatically. This failsafe baud rate is used only if

the attempt fails, and the value must not be changed. This option is set to

115200 by default.

Sets the remote console terminal type. This option is set to VT100/VT220 by

default.