Dell Force10 S2410 Hızlı Başlangıç Kılavuzu - Sayfa 13

Sunucu Dell Force10 S2410 için çevrimiçi göz atın veya pdf Hızlı Başlangıç Kılavuzu indirin. Dell Force10 S2410 31 sayfaları. Installing the s2410 system
Ayrıca Dell Force10 S2410 için: Manuel (42 sayfalar)

Sayfayı Yazdır

Step

Task

Position the XFP so it is in the upright position (XFPs on the bottom

(even-numbered ports) are upside down; odd-numbered ports (on top)

install right-side up), with the bail latch on top in the closed position, as

shown here. For details on XFP installation, see the instruction that

accompanies the XFP.

Insert the XFP gently into the port until it snaps into place. (The design

of the XFP prevents it from seating incorrectly.)

The XFP transceiver contains Rx and Tx labels on the two fiber optic

connections, and the connections have keyways that prevent inserting

the cables incorrectly.

CAUTION: Before connecting a transceiver to a source, check the receive

power of the transceiver with an optical power meter. Generally, Dell Force10

specified optics are not to be subjected to receive power higher than that

stipulated by the optic specification. If the optic is exposed to optical power in

excess of the specification, there is a high likelihood that it will be damaged.

Optical specifications for Dell Force10 branded devices are at the following

URL: http://www.force10networks.com/products/mediaspecifications.asp

S2410 Specifications

Chassis Physical Design

Parameter

Height

S2410P

1.73 inches (4.4 cm)

S2410CP

1.73 inches (4.4 cm)

Installing the Hardware