Dell Force10 S2410-01-10GE-24P Manuel - Sayfa 23

Sunucu Dell Force10 S2410-01-10GE-24P için çevrimiçi göz atın veya pdf Manuel indirin. Dell Force10 S2410-01-10GE-24P 42 sayfaları. Installing the s2410 system
Ayrıca Dell Force10 S2410-01-10GE-24P için: Uygulama Notu (6 sayfalar), Hızlı Başlangıç Kılavuzu (31 sayfalar)

Sayfayı Yazdır

1. Physical Interfaces

Accessing Ports

This chapter contains the following sections:

•

Accessing the Console Port

•

Accessing the Ethernet Management Port on page 24

•

Accessing CX4 Ports on page 24

•

Accessing XFP Ports on page 25

Accessing the Console Port

You must first connect the console port to a management terminal in order to use the Command Line

Interface (CLI) to set up alternative management interfaces, such as an SFTOS Web User Interface

connection to the Ethernet Management port (see

For more on using alternative management interfaces, see the S2410 Quick Reference or the Getting

Started chapter of the SFTOS Configuration Guide for the S2410.

Connect the RJ-45/DB-9

adapter that is shipped with

the S2410 system to the RJ-

45 cable.

Console port pinout:

Pin 1 = NC (unused)

Pin 2 = DTR (output)

Pin 3 = TxD (output)

Pin 4 = GND

Pin 5 = GND

Pin 6 = RxD (input)

Pin 7 = DSR (input)

Pin 8 = NC

To access the console port, use the following the procedure:

CAUTION: You must use a rollover cable (same as used for the E-Series) to connect to the console port. This

is in contrast to the straight-through cable used on other S-Series models. In more detail, the cable

connections are pin 1 to pin 8, pin 2 to pin 7, pin 3 to pin 6, pin 4 to pin 5, and the inverse for pins 5 through 8.

Step

Task

If necessary, connect the RJ-45/DB-9 adapter that is shipped with the S2410 system to the end of the RJ-45 cable

that will connect to your terminal.

Verify your terminal default settings match the default settings, as listed above, on the console port:

Figure 5-1. S2410 Console Port

Accessing the Ethernet Management Port on page

Set your initial console terminal settings

to match the default console settings on

the switch:

• 9600 baud rate

• No parity

• 8 data bits

• 1 stop bit

• No flow control (console port only)

After establishing a connection, you can

modify the settings to match at each end

of the connection.

24).

Accessing Ports