Dell Force10 S25 Series Hızlı Başlangıç Kılavuzu - Sayfa 17
Sunucu Dell Force10 S25 Series için çevrimiçi göz atın veya pdf Hızlı Başlangıç Kılavuzu indirin. Dell Force10 S25 Series 27 sayfaları. Basic layer 2 setup and buffer tuning of the s25p for storage environments
Ayrıca Dell Force10 S25 Series için: Yapılandırma Kılavuzu (8 sayfalar)
Sayfayı Yazdır
Installing the Software
Navigating CLI Modes
The FTOS prompt changes to indicate the CLI mode. You must move linearly
through the command modes, with the exception of the end command which
takes you directly to EXEC Privilege mode; the exit command moves you up
one command mode level.
Console Access
Access the command line through a serial console port or a Telnet session.
When the system successfully boots, you enter the command line in the EXEC
mode.
NOTE: You must have a password configured on a virtual terminal line before you
can Telnet into the system. Therefore, you must use a console connection when
connecting to the system for the first time.
Serial Console
The RS-232 console port is labeled on the chassis. It is in the upper right-hand
side, as you face the PSU side of the chassis.
Installing the Software
2
15