Dell Force10 S25 Series 빠른 시작 매뉴얼 - 페이지 17

{카테고리_이름} Dell Force10 S25 Series에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell Force10 S25 Series 27 페이지. Basic layer 2 setup and buffer tuning of the s25p for storage environments
Dell Force10 S25 Series에 대해서도 마찬가지입니다: 구성 매뉴얼 (8 페이지)

페이지 인쇄

Installing the Software

Navigating CLI Modes

The FTOS prompt changes to indicate the CLI mode. You must move linearly

through the command modes, with the exception of the end command which

takes you directly to EXEC Privilege mode; the exit command moves you up

one command mode level.

Console Access

Access the command line through a serial console port or a Telnet session.

When the system successfully boots, you enter the command line in the EXEC

mode.

NOTE: You must have a password configured on a virtual terminal line before you

can Telnet into the system. Therefore, you must use a console connection when

connecting to the system for the first time.

Serial Console

The RS-232 console port is labeled on the chassis. It is in the upper right-hand

side, as you face the PSU side of the chassis.

Installing the Software