Dell Force10 S25-01-GE-24P Manuel - Sayfa 20
Sunucu Dell Force10 S25-01-GE-24P için çevrimiçi göz atın veya pdf Manuel indirin. Dell Force10 S25-01-GE-24P 48 sayfaları. Installing the s25p system
Ayrıca Dell Force10 S25-01-GE-24P için: Yapılandırma Kılavuzu (8 sayfalar)
Sayfayı Yazdır
Four-Post Rack-mounting with Threaded Rails
Ensure that there is adequate clearance surrounding the cabinet or rack to permit access and airflow. If you
are installing two S25P switches side-by-side, position the two S25P chassis at least 5 inches (12.7 cm)
apart to permit proper airflow. Follow the steps below to install a switch into a 4-post 19-inch equipment
rack, using the attached front mounting brackets and the optional adjustable rear-mounting brackets.
Step
Task
Align the three screw holes of the adjustable rear mounting bracket with the three holes in the S25P chassis, and
1
secure the mounting bracket with three screws.
Figure 7 Four-Post Rack-mounting with Threaded Rails
2
Insert the S25P into the rack, and secure the chassis to the front post with two screws. Then secure the chassis to
the rear posts with two screws.
Figure 8 Four-Post Rack-mounting with Threaded Rails .
20
Installing the S25P