Dell PowerEdge 1950 Kurulum Kılavuzu - Sayfa 9

Sunucu Dell PowerEdge 1950 için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. Dell PowerEdge 1950 10 sayfaları. Trusted platform module (tpm) update
Ayrıca Dell PowerEdge 1950 için: Bilgi Güncellemesi (50 sayfalar), Kurulum Bilgileri (11 sayfalar), Güncelleme (2 sayfalar)

Sayfayı Yazdır

9 Replace the cooling shroud. See "Installing the Cooling Shroud" in your

Hardware Owner's Manual.

10 Close the system. See "Closing the System" in your Hardware Owner's

Manual.

11 Reconnect the system to power and turn on the system and attached

peripherals.

Installing the SATA Optical Drive – PowerEdge 2900 and 1900

1 If the mounting screws are not attached to the drive, install them now.

2 Align the mounting screws with the bay slide slots and insert the optical

drive into the optical drive bay until the spring latch engages.

3 Connect the SATA cable to the back of the optical drive.

4 Use the appropriate power cable provided in the optical drive kit and

connect one end to the optical drive and the other to the power supply as

follows:

–

For a PowerEdge 2900 system, connect to the CD/TBU connector on

the system backplane. See Figure 1-5.

–

For a PowerEdge 1900 system, connect to an available power supply

cable.

5 Replace the center fan bracket. See "Replacing the Center Fan Bracket" in

your Hardware Owner's Manual.

6 Replace the fans in the center fan bracket.

7 Route the SATA cable to the system board over the top of the fan bracket

and connect the cable to the SATA connector on the system board. See

Figure 1-5.

–

For a PowerEdge 2900, use the SATA_B connector.

–

For a PowerEdge 1900, use the SATA_D connector.

Installing a SATA Optical Drive