Dell PowerEdge 2420 Manuel

Sunucu Dell PowerEdge 2420 için çevrimiçi göz atın veya pdf Manuel indirin. Dell PowerEdge 2420 20 sayfaları. Rack enclosures
Ayrıca Dell PowerEdge 2420 için: Manuel (20 sayfalar), Manuel (17 sayfalar), Manuel (12 sayfalar), Manuel (10 sayfalar), Manuel (10 sayfalar), Manuel (9 sayfalar), Manuel (9 sayfalar), Manuel (10 sayfalar), Manuel (12 sayfalar), Manuel (11 sayfalar), Manuel (8 sayfalar), Teknik Kılavuz (37 sayfalar)

Sayfayı Yazdır
Dell PowerEdge 2420 Manuel
About Warnings
WARNING:
or death.

Installing the Rack Stabilizer Feet

WARNING:
installed could cause the rack to tip over, potentially resulting in bodily injury under
certain circumstances. Therefore, always install the stabilizer feet before installing
components in the rack.
WARNING:
the rack on its slide assemblies at one time. The weight of more than one extended
system could cause the rack to tip over and cause injury.
WARNING:
bottom 3-U spaces of the rack cabinet.
NOTE:
For complete rack installation instructions, see your rack installation guide.
The stabilizer feet help prevent the rack from tipping over when a system
or other component is pulled out of the rack with the slide assemblies fully
extended.
Install stabilizer feet on the rack as follows:
•
Install front and side stabilizer feet on a standalone rack.
•
Install front stabilizer feet on all racks in a suite, and install left or right
stabilizer feet on the racks at each end of a suite.

Recommended Tools and Supplies

You may need the following tools and supplies to install the rack:
•
12-mm wrench
•
Keys to the rack doors and side panels
October 2008
A WARNING indicates a potential for property damage, personal injury,
Installing systems in a rack without the front and side stabilizer feet
After installing systems in a rack, never pull more than one system out of
For stability, you must ensure that a minimum of 50 lbs. is installed in the