Dell PowerEdge 4x00 Series Kurulum Kılavuzu - Sayfa 33
Sunucu Dell PowerEdge 4x00 Series için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. Dell PowerEdge 4x00 Series 37 sayfaları. Rack installation guide
Ayrıca Dell PowerEdge 4x00 Series için: Kurulum Kılavuzu (28 sayfalar), Raf Kurulumu (37 sayfalar), Kullanıcı Kılavuzu (42 sayfalar), Raf Kurulumu (34 sayfalar)
Sayfayı Yazdır
05KCEeb1.fm Page 17 Thursday, September 14, 2000 1:37 PM
5HY ),/( /2&$7,21 5???0XOWL?9?.&(HEIP
support.dell.com
Reversing the Cable-Management Arm Installation
1.
Turn the cable-management arm over (see Figure 1-13).
pull pin
offset
hinge
rail-mounting
plate
Figure 1-13. Reversing the Cable-Management Arm
2.
Remove the pull pins from the offset hinge of the cable-management arm.
3.
Remove the rail-mounting plate.
NOTE: Make note of the orientation of the rail-mounting plate to the vertical rail.
4.
Pull the hinge away from the cable-management arm assembly.
5.
Position the offset hinge next to the cable-management arm assembly.
6.
Replace the pull pin with the ring facing up.
7.
Replace the rail-mounting plate in the same orientation to the opposite vertical
rail.
8.
Replace the second pull pin with the ring facing up.
9.
Perform the steps to install the cable-management arm. The opposite vertical rail
and the slotted pocket on the opposite side of the cable tray are used for reverse
the installation of the cable-management arm.
'(// &21),'(17,$/ 3UHOLPLQDU\
latch pin
Rack Installation Guide
1-17