Allied Telesis AT-9900 Series İşlev Kılavuzu

Yazılım Allied Telesis AT-9900 Series için çevrimiçi göz atın veya pdf İşlev Kılavuzu indirin. Allied Telesis AT-9900 Series 18 sayfaları. How to set up pppoe between a linux client and access concentrator
Ayrıca Allied Telesis AT-9900 Series için: Nasıl Yapılandırılır (9 sayfalar), Nasıl Yapılır (8 sayfalar)

Sayfayı Yazdır

Allied Telesis AT-9900 Series İşlev Kılavuzu

AlliedWare

Configure Hardware Filters on AT-9900, x900-48,

How To |

and x900-24 Series Switches

Introduction

The AT-9900, x900-48, and x900-24 series switches support a powerful hardware based

packet-filtering facility.

These switches can filter on a range of Layer 2, Layer 3, and Layer 4 packet attributes, and

perform a variety of different actions on the packets that match the filters.

Because the filters are hardware-based, they put no load on the CPU of the switch, and have

no affect on the throughput of the switch. It is possible to configure over 1000 different

filters, and still have complete wire speed throughput on the switch.

The following configuration methods are available:

To filter traffic across all ports on the switch, create dedicated hardware filters.

To filter traffic on a per-port basis, apply filtering actions to QoS flow groups or traffic

classes.

This Note only describes method 1. Method 2 is described in How To Configure Filtering Actions

on QoS Flow Groups and Traffic Classes, available from

literature/howto.aspx.

C613-16058-00 REV C