Dell PowerVault MD3420 Kullanıcı El Kitabı - Sayfa 18
Depolama Dell PowerVault MD3420 için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Dell PowerVault MD3420 47 sayfaları. Storage arrays
Ayrıca Dell PowerVault MD3420 için: Başlangıç Kılavuzu (8 sayfalar), Dağıtım Kılavuzu (27 sayfalar)
Sayfayı Yazdır
3.
Secure the bezel with the keylock.
Physical Drives
SAFETY Models AMT E03J and E04J
Models AMT, E03J, and E04J are intended for installation only in restricted access locations as defined in
cl 1.2.7.3 of IEC 60950-1:2005.
Depending on your configuration, your array either supports up to twenty-four 2.5-inch SAS physical
drives or up to twelve 3.5-inch SAS physical drives in internal drive bays. Physical drives are connected to
a backplane through physical-drive carriers and can be configured as hot-swappable.
Removing a 2.5 Inch Physical-Drive Blank
CAUTION: To maintain proper system cooling, all empty physical-drive slots must have physical-
drive blanks installed.
1.
If installed, remove the front bezel.
2.
Press the release button and slide the physical-drive blank out until it is free of the physical-drive slot.
Figure 9. Removing and Installing a 2.5 Inch Physical-Drive Blank (MD3420 only)
1.
physical-drive blank
Installing a 2.5 Inch Physical-Drive Blank
1.
If installed, remove the front bezel.
2.
Insert the physical-drive blank into the physical-drive slot until the release button clicks into place.
3.
If applicable, install the front bezel.
Removing a 3.5 Inch Physical-Drive Blank
CAUTION: To maintain proper system cooling, all empty hard-drive slots must have drive blanks
installed.
1.
If installed, remove the front bezel.
2.
Press the release button and slide the physical-drive blank out until it is free from the physical-drive
slot.
18
2.
release button