Dell Force 10 Manuel - Sayfa 12

Anahtar Dell Force 10 için çevrimiçi göz atın veya pdf Manuel indirin. Dell Force 10 29 sayfaları. Implementing fcoe in the linux operating system

Implementing FCoE in the Linux Operating System

Setting up FCoE for SLES 11 SP 2

If FCoE support has not been installed in SLES 11 SP2, it must be installed. To verify if FCoE support

was installed in SLES 11 SP2, perform the following steps:

1. Log-in as root, then the start YaST2 Control Center by running the yast command. From

YaST2, select Network Services in the left-side menu, then use the Tab key switch to the

right-side menu. Use the arrow keys to scroll up and down the list of Network Services and

look for FCoE Client Configuration ; if FCoE Client Configuration is not listed, as

in Figure 5, then FCoE support is not installed in SLES 11 SP2, and must be installed at this

time.

Figure 5.

FCoE support not installed.