Dell Force 10 Manuel - Sayfa 14

Anahtar Dell Force 10 için çevrimiçi göz atın veya pdf Manuel indirin. Dell Force 10 29 sayfaları. Implementing fcoe in the linux operating system

Implementing FCoE in the Linux Operating System

Figure 7.

You may be prompted to accept any Automatic Changes to resolve dependency issues; if this

happens, select OK to allow the installation to proceed. After the packages install, you are

returned to the YaST2 Control Center. When finished, quit the YaST2 Control Center.

Configure the FCoE client VLAN

Next, configure the FCoE client VLAN by performing the following steps:

1. Start the YaST2 Control Center using the yast command, then select Network Services ,

and then FCoE Client Configuration , as in Figure 8.

Selecting FCoE packages for installation.