Dell Networking N30 Series Kurulum Kılavuzu - Sayfa 44
Anahtar Dell Networking N30 Series için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. Dell Networking N30 Series 49 sayfaları.
Sayfayı Yazdır
The setup wizard configures the initial values. After completing the wizard, the switch is configured as follows:
•
SNMPv2 is enabled and the community string is set up. SNMPv3 is disabled by default.
•
The admin user account is set up as defined.
•
A network management system is configured. From the management station, you can access the SNMP, HTTP, and CLI interfaces.
You may also choose to allow all IP addresses to access these management interfaces by choosing the (0.0.0.0) IP address.
•
DHCP is enabled on the OOB management interface.
•
An IP address is configured for the VLAN 1 routing interface.
•
A default gateway address is configured.
NOTE:
In the following example, the possible user options or default values are enclosed in [ ]. If you press Enter without
defining options, the default value is accepted. Help text is in parentheses.
Dell Easy Setup Wizard Console Example
The following example contains the sequence of prompts and responses associated with running a Dell Easy Setup Wizard session, using
the input values listed previously.
After the switch completes the POST and is booted, the following dialog appears:
Unit 1 - Waiting to select management unit)>
Applying Global configuration, please wait...
Welcome to Dell Easy Setup Wizard
The Setup Wizard guides you through the initial switch
configuration, and gets you up and running as quickly
as possible. You can skip the setup wizard, and enter
CLI mode to manually configure the switch. You must
respond to the next question to run the setup wizard
within 60 seconds, otherwise the system will continue
with normal operation using the default system
configuration. Note: You can exit the setup wizard at
any point by entering [ctrl+z].
Would you like to run the setup wizard (you must
answer this question within 60 seconds)? [Y/N] y
Step 1:
The system is not set up for SNMP management by
default. To manage the switch using SNMP (required for
Dell Network Manager) you can
. Set up the initial SNMP version 2 account now.
. Return later and set up other SNMP accounts. (For
more information on setting up an SNMP version 1 or
3 account, see the user documentation).
Would you like to set up the SNMP management interface
now? [Y/N] y
To set up the SNMP management account you must specify
the management system IP address and the "community
string" or password that the particular management
system uses to access the switch. The wizard
automatically assigns the highest access level
[Privilege Level 15] to this account. You can use Dell
Network Manager or other management interfaces to
change this setting, and to add additional management
system information later. For more information on
adding management systems, see the user documentation.
To add a management station:
Starting and Configuring the N30xx System
43