Dell Networking N30 Series Kurulum Kılavuzu - Sayfa 46

Anahtar Dell Networking N30 Series için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. Dell Networking N30 Series 49 sayfaları.

This is the configuration information that has been

collected:

SNMP Interface = "public"@10.1.2.100

User Account setup = admin

Password = ********

Out-of-band IP address = DHCP

VLAN1 Router Interface IP = 10.1.1.200 255.255.255.0

Default Gateway = 10.1.1.1

Step 6:

If the information is correct, please enter (Y) to

save the configuration and copy the settings to the

start-up configuration file. If the information is

incorrect, enter (N) to discard the configuration and

restart the wizard: [Y/N] y

Thank you for using the Dell Easy Setup Wizard. You

will now enter CLI mode.

Applying Interface configuration, please wait...

Next Steps

After completing the initial configuration described in this section, you can connect the OOB port to your management network for out-of-

band remote management, or you can connect any of the front-panel switch ports to your production network for in-band remote

management.

If you specified DHCP for the OOB or VLAN 1 management interface IP address, the interface acquires its IP address from a DHCP server

on the network. To discover the dynamically assigned IP address, use the console port connection to issue the following commands:

•

For the OOB interface, enter show ip interface out-of-band.

•

For the VLAN 1 routing interface, enter show ip interface.

To access the Dell OpenManage Switch Administrator interface, enter the OOB management interface IP address into the address field of

a web browser. For remote management access to the CLI, enter the VLAN 1 management interface IP address into a Telnet or SSH

client. Alternatively, you can continue to use the console port for local CLI access to the switch.

Your N30xx switch supports basic switching features such as VLANs and spanning tree protocol. The N30xx switches also support

advanced Layer 3 features such as dynamic routing and multicast. Use the web-based management interface or the CLI to configure the

features your network requires. For information about how to configure the switch features, see the User's Configuration Guide or CLI

Reference Guide available on the support site: dell.com/support/manuals.

Performing Initial Configuration on Dell Networking OS

9.11(0.0)

Before proceeding, ensure that the C9010 switch runs Dell Networking OS version 9.11(0.0) or later.

The following section explains the procedure to set up an N30xx switch if it runs the Dell Networking OS version 9.11(0.0) or later:

To complete the hardware installation, install the system in a rack, attach an uplink cable to a parent C9010 switch, set up an N30xx stack

if required, and power on the port extender.

To provision an N30xx system, configure basic software settings from the C9010 console either before or after you connect the N30xx to

a C9010. For example, you can preconfigure software settings to download from the parent C9010 after you power on the N30xx.

Perform provisioning preconfigured N30xx settings using a discovery and authentication process through a port-channel interface on the

C9010.

Starting and Configuring the N30xx System