Dell Networking Z9500 Başlangıç Kılavuzu - Sayfa 14
Anahtar Dell Networking Z9500 için çevrimiçi göz atın veya pdf Başlangıç Kılavuzu indirin. Dell Networking Z9500 34 sayfaları. Z9500 switch
Ayrıca Dell Networking Z9500 için: Kurulum Kılavuzu (47 sayfalar)
Sayfayı Yazdır
Securing the Chassis Ground
After you mount the chassis, secure the chassis ground as follows:
1.
Locate the chassis ground connector nuts on the chassis rear.
2.
Install the grounding cables to the ground nuts. The grounding cable must comply with your local
electrical codes in size and color (typically the color is green or green with yellow stripe).
NOTE: For proper ventilation, position the chassis in an equipment rack (or cabinet) with a
minimum of 5 inches (12.7 cm) of clearance around exhaust vents. The acceptable ambient
temperature ranges are listed in the Environmental Parameters section.
Use M5 screws.
3.
Tighten the screws (torque should be between 18 and 24 inch/lbs).
4.
Connect the opposite end of the grounding cable to the nearest appropriate facility grounding post.
Figure 3. Cable Connector
Installing Fan Modules
The chassis requires five fan modules to be installed for normal configuration. The airflow direction must
be from I/O to Utility.
Important Points to Remember for Installing a Fan Module
14
Getting Started Guide