Dell PowerConnect M8428-k Kullanıcı Kılavuzu - Sayfa 23

Anahtar Dell PowerConnect M8428-k için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Dell PowerConnect M8428-k 23 sayfaları. Dell poweredge m710 and m710hd - system memory update
Ayrıca Dell PowerConnect M8428-k için: Güncelleme Kılavuzu (32 sayfalar), Sürüm Notları (27 sayfalar), Manuel (25 sayfalar), Güncelleme Kılavuzu (1 sayfalar)

Dell PowerConnect M8428-k Kullanıcı Kılavuzu
Rev 1.0
Table 9 - SFP+ Pinout
Pin
Symbol Name
15
VccR
16
VccT
17
VeeT
18
TD+
19
TD-
20
VeeT
a. Circuit ground is internally isolated from chassis ground.
b. T
FAULT
Ohms resistor on the host board if intended for use. Pull up voltage should be between 2.0V
to Vcc + 0.3V. A high output indicates a transmitter fault caused by either the TX bias cur-
rent or the TX output power exceeding the preset alarm thresholds. A low output indicates
normal operation. In the low state, the output is pulled to <0.8V.
c. Laser output disabled on TDIS >2.0V or open, enabled on TDIS <0.8V
d. Should be pulled up with 4.7kΩ – 10kΩ on host board to a voltage between 2.0V and 3.6V.
MOD_ABS pulls line low to indicate module is plugged in.
e. LOS is open collector output. Should be pulled up with 4.7kΩ – 10kΩ on host board to a
voltage between 2.0V and 3.6V. Logic 0 indicates normal operation; logic 1 indicates loss of
signal.
24
Receiver Power Supply
Transmitter Power Supply
Transmitter Ground (Common with Receiver Ground)
Transmitter Non-Inverted DATA in. AC Coupled.
Transmitter Inverted DATA in. AC Coupled.
Transmitter Ground (Common with Receiver Ground)
is an open collector/drain output, which should be pulled up with a 4.7k – 10k
Description
a
a