AVZ Twins Piazzola Kurulum Talimatı - Sayfa 11

Aksesuarlar AVZ Twins Piazzola için çevrimiçi göz atın veya pdf Kurulum Talimatı indirin. AVZ Twins Piazzola 20 sayfaları. Gastro awning

Assembly instructions Twins

Subassembly Twins Piazzola

1. Pour a concrete foundation. Minimum dimensions: Length 85 cm, width 85 cm and height 20 cm.

Allow the concrete to cure properly.

2. Drill the holes in the foundation and fix the M16 threaded ends in place (slotted hole width is

18 mm).

3. Cut the length material to the correct size (see the enclosed materials list).

4. You determine the height of the legs. At a projection of 5 m and a minimum angle of 17°, the

upright length is 3,7 m.

5. Make the holes (Ø 11 mm) in the top of the leg as shown in the drawing below.

Attention! If water enters the supports, drill a hole in the bottom of it. This to prevent damage from

frost.

6. Drill holes with a cross-section of 11 mm in the aluminium support beam (see drawing).

Piazzola

Butterfly awning

Pour concrete foundation

85x85x20 cm

Twins Piazzola EN 27-08-2018

Side top cover support

Page 11